I have come across one but I have no idea how to install and run it as it doesn't seem to have anything as simple as an. How can I get hold of the Simconnect configure application. Which, if any do I need to have installed of the above Simconnects and what do they do?Ģ. V3.0 installed on and I am pretty sure is part of EZYDOK.ġ. V9.0 installed on and could be connected to another Saitek installation.Ĥ. V2.0 installed on 17/5/18 and could be connected to the installation of some Saitek hardware/software.ģ. V5.0 which was installed on and could be connected to the installation of the Cessna 162 Skycatcher.Ģ. I have looked in the install lists and find that I have the following versions of Simconnect:ġ. If so does anyone know which of the versions of Simconnect below is the correct one. Am I right in assuming that the system uses Simconnect to pass information from the hardware to the appropriate software. I use EZYDOK, also known as EZCA to set up the views in many different aircraft and each tied to a button on the Yoke and throttles. Sometimes FSX crashes and says that there is a problem with Simconnect and to reconfigure it. The problem is shown by sometimes I get a message from Ezydok saying that it cannot find the FSX exe. Recently I have been having problems relating to the connection between the physical part of my setup, ie yoke, pedals, throttles etc, and I think it is related to a problem with Simconnect.
0 Comments
Leave a Reply. |